Aluminium 1060 Sheet in H24 Temper Strong & corrosion resistant
Image

1060 Aluminium Sheet

Aluminum alloy 1060 is a commercially pure aluminum (99.6% aluminum) with excellent formability and corrosion resistance. It's commonly used in applications where high corrosion resistance is not a primary requirement, and it is suitable for various industrial applications.


Mechanical Properties:
Tensile Strength:23,000 psi (159 MPa)
Yield Strength: 16,000 psi (110 MPa)
Elongation: 12%

Physical Properties:
Density: 2.70 g/cm³ (0.0975 lb/in³)
Melting Range: 643°C-660°C (1190°F-1220°F)

Typical Uses:
Reflectors
Decorative parts
Nameplates and labels
Chemical and food handling equipment
Signage
Heat exchangers
Welding:
Alloy 1060 is readily weldable using standard methods such as gas, electric, resistance, and spot welding.
Corrosion Resistance:
1060 has good corrosion resistance, particularly in atmospheric conditions. However, it is not suitable for applications where high corrosion resistance is critical.
Considerations
Alloy 1060 is known for its excellent electrical conductivity, thermal conductivity, and weldability. It is often used in applications where these properties are important.

1060 Aluminium Sheets


Alloy: 1060 Aluminium Sheets


Temper: O H14 H24 H18 / T351 T3 T4 T651 T6 / H14 H24 H26 H16 / H32 H111 H321 H116 H112 / T6 T651 / T651 T6 T7451
O : Fully annealed, soft condition with the lowest strength. Excellent workability for deep drawing or spinning.
H12: Strain-hardened, 1/4 hard. Increased strength achieved by cold working and partial annealing.
H14: Strain-hardened, 1/2 hard. Higher strength and improved formability compared to H12.
H16: Strain-hardened, 3/4 hard. Increased strength with some retention of formability.
H18: Strain-hardened, full hard. Maximum strength achieved through cold working and annealing.


Thickness: 0.2mm-300mm


Width: 500mm-3000mm


Standard: GB/ 3880-2012 ASTMB209 EN485


Surface Treatment: Mill finish / Brush polish


PVC Coated: One side or two side PVC


MOQ: The inventory has no MOQ


Packing: Standard Export Packing


Port of Dispatch: It depends on the supplier's location and shipping arrangements


Delivery Time: The inventory is 5-7 days . 25-30 days for customized products


Payment: TT / LC / TT+LC


Alloy 1060 Composition:

Aluminum (Al): 99.2%
Silicon (Si): 0.25%
Iron (Fe): 0.35%
Copper (Cu): 0.05%
Manganese (Mn): 0.03%
Magnesium (Mg): 0.03%
Titanium (Ti): 0.03%
Zinc (Zn) 0.05%

Address

67,KIKA STREET,GULALWADI,MUMBAI MAHARASHTRA,400004.
Phone: 02267521208
Mobile: +91 9769223965
Email: team@6061aluminium.com

logo