5052 Aluminium Sheet
Aluminum alloy 5052 is a non-heat-treatable alloy known for its excellent corrosion resistance, particularly in marine environments. It has good workability and is commonly used in applications that require moderate strength.
| Mechanical Properties: |
|---|
|
Tensile Strength:33,000 psi (228 MPa) Yield Strength:28,000 psi (193 MPa) Elongation:12% |
| Physical Properties: |
|
Density: 2.68 g/cm³ (0.0975 lb/in³) Melting Range: 607°C-650°C (1125°F-1202°F) |
| Typical Uses: |
| Marine applications (boat hulls, shipbuilding) | Architecture and construction | Automotive components | Cooking utensils | Electrical appliances | General sheet metal work |
| Welding: |
| Alloy 5052 is readily weldable using standard methods such as gas, electric, resistance, and spot welding. |
| Corrosion Resistance: |
| 5052 has excellent corrosion resistance, particularly in marine environments. It is also resistant to saltwater, making it a common choice for applications in coastal regions. |
| Considerations |
| Alloy 5052 is known for its good formability, high fatigue strength, and above-average machinability. It is often used in situations where anodizing or other coatings are applied. |
5052 Aluminium Sheets
Alloy: 5052 Aluminium Alloy
Temper:
O H14 H24 H18 / T351 T3 T4 T651 T6 / H14 H24 H26 H16 / H32 H111 H321 H116 H112 / T6 T651 / T651 T6 T7451
H32: Strain-hardened and stabilized. The work-hardening rate is moderate, and the product has medium strength.
H34: Strain-hardened and stabilized. Similar to H32 but with higher strength.
H36: Strain-hardened and stabilized. Higher strength than both H32 and H34, but with reduced formability.
H38: Strain-hardened and stabilized. The highest strength in the 5052 series, but with the lowest formability.
O: Fully annealed, soft condition with the lowest strength. Excellent workability for deep drawing or spinning.
Thickness: 0.2mm-300mm
Width: 500mm-3000mm
Standard: GB/ 3880-2012 ASTMB209 EN485
Surface Treatment: Mill finish / Brush polish
PVC Coated: One side or two side PVC
MOQ: The inventory has no MOQ
Packing: Standard Export Packing
Port of Dispatch: It depends on the supplier's location and shipping arrangements
Delivery Time: The inventory is 5-7 days . 25-30 days for customized products
Payment: TT / LC / TT+LC
Alloy 5052 Composition: |
|
| Aluminum (Al): | 95.7%-97.7% |
| Magnesium (Mg): | 2.2%-2.8% |
| Iron (Fe): | 0.0%-0.25% |
| Copper (Cu): | 0.1% |
| Manganese (Mn): | 1.0%-1.5% |
| Zinc (Zn) | 0.1% |
| Chromium (Cr): | 0.15%-0.35% |
| Titanium (Ti): | 0.1% |
| Others: | 0.05% (each) 0.15% (total) |
